Craft is the best of the best
QEEDON has been in the business of automotive lighting since 2013. Currently designing and Manufacturing LED lights include LED headlights, LED fog lights, work lights, auxiliary lights, ambient lights and turn signal lights,Our factory is covering an area of 6,000m³, the production department now have over 30 employees, an annual sales figure that produces 150,000 units, exceeds USD 3M and are currently exporting 95% of our production worldwide. Our well-equipped facilities and excellent quality control throughout all stages of production enables us to guarantee total customer satisfaction.
product
Now we possess 10 operating production line for led headlight and 4 operating production line for led bulb. Everyone is equipped with the advanced technology and facilities. As long as a new product is put into production, it can be mass-produced immediately.
Automation is the backbone of our manufacturing. Each of our automation lines includes laser, etch solder stenciling component pick-and-place and Reflow soldering, the end of each of those assembly lines uses automated optical inspection to inspect every component in every solder joint on every sembly we produce.
Exquisite Technological Process
We do the performance tested and torture tested for longevity in this room.
For the UV tester, we put individual components in it to ensure that they gonna last in a tough sun irradiance. Each component is tested for its fade, its aging and potential crocking. The component will stay in the UV tester for 2 months, if they don’t pass the test, we will send back to the engineer for re-develop, re-design, new material, new coating, and then re-testing.
QC Process
We have a strict quality control process from incoming raw material to finished good. Each product type has a different quality control standard to ensure they meet strict requirements. They mainly will experienced the four inspection stages below,
Incoming Quality Control – All incoming raw material are checked before used. Varies measurements are taken to check against approved data. Once rejected, raw material is sent back for further examination.
In Process Quality Control– We perform inspections during the manufacturing process. The frequency of inspection depends on the quality standard set forth by the project.
Final Quality Control – All finished goods are inspected according to our quality standard for each project. Products are sampled according to the AQL sampling rate before it leave our production plant into the warehouse.
Outgoing Quality Control – Our QC team will randomly check any finished goods in the warehouse before it goes out for shipment. This last inspection ensures zero defect goods are shipped to our customer.
